Bildegalleri
Burmeister 933 Clone Weilang Audio Klasse A
Beskrivelse av varen
Selger en fantastisk forsterker som er bygget med kvalitetskomponenter
Ekstremt strømsterk!! 8 stk ELNA 10000uf kondensatorer.
Mye hi-fi for pengene, umulig å matche til prisen.
A/B klasse
Første 10W skal vel være klasse A
Oppgitt til
2*120w i 4 ohm. B klasse.
Men målt til 130W i 8ohm i test.
Stereo 2.0
Klasse A/B
Kan sendes..
Imitation Burmester 933 amplifier circuit amplifier
The Burmester's equipment, sound is delicate and gorgeous, dynamic powerful, strong sense of the site is known, is now internationally recognized the highest degree of HI-END one of the high-end brands. Its nearly two years began to vigorously develop the Chinese market in the recent major audio show can see its shadow, each appearance will be one of the best, get a lot of Shaoyou recognition, its strength and Quality can be seen.
The Burmester 's full range of post-amplifiers has a very low output impedance and a very high damping factor. Even with an output power of only 120W @ 4Ω, the 933 also has the perfect low-frequency control. For some "notorious" difficult to control's speakers can cope with, match well with "Dyn-audio" speakers, it is more outstanding performance, with all-conquering noble tone.
Parameters:
Dimensions: 360 * 268 * 80mm
Net Weight: 7.6KG
Package weight:10.5KG
Output Power: 130WX2 8ohms (load range 2-16 ohms
Power chip: orginal 2SC3264 SSA1295
Filtering capacitors: ELNA FO AUDIO 10000UF
Potentiometer: Japon ALPS27
American CMC input terminal
The Technical parameters:
Circuit structure: fully symmetrical differential X-AMP circuit
Class A/B amplifier
Coupling: DC coupling
Rated continuous output power:
Original factory standard power: 70W @ 8ohms; 120W @ 4ohms; 240W @ 4ohms bridge
Measured this amp power: more than 80W @ 8 ohms
Power transformer: 300W 33v
Rated continuous output current: 8A peak
Instantaneous output current: 17A peak
Input Sensitivity: 700mV
Input impedance: balanced 1.88k; single-ended 12k
Output impedance: less than 5micro ohms
Damping coefficient: greater than 3000 @ 8 ohms
Gain: 30.5 dB
Frequency corresponding: -3dB @ 220kHz / rated power output
Total Harmonic Distortion + Noise:
0.002% @ 8Ω / 10W / 1kHz / 22kHz bandwidth RMS
0.011% @ 8 ohm / 70W / 1kHz / 22kHz bandwidth RMS
Noise base: 85uV @ No signal input RMS
SNR: 107dB @ rated power output RMS
Input voltage: 110/120v AC , or 220-240v
OP-amp is OP07, it's for center point service ,it's not for preamp function
Brukerprofil
Du må være logget inn for å se brukerprofiler og sende meldinger.
Logg innAnnonsens metadata
Sist endret: 10.2.2025 kl. 17:51 ・ FINN-kode: 244818182