Solar Lamp LED for vegg med PIR

Solar Lamp LED for vegg med PIR

Glem kabling og dyr installasjon for utelys, denne klarer seg selv, kan stilles inn på timer eller manuell eller automatisk, følger og med fjernkontroll.

Mere info:



Practical LED wall lamp with PIR sensor, solar panel and two Li-Ion cells 18650 3.7V / 1200mAh. The cells are housed in a holder and can be easily replaced. Ideal for placement in outdoor areas to be illuminated for safe passage.


Product parameters:

- continuous light mode without the influence of the PIR sensor for 60 minutes: it can be set with the remote control by pressing the ON button (max. power) or MODE3 (half power) or by repeatedly pressing the control button directly on the light body. In this mode, the luminaire will light continuously for 60 minutes without the influence of a motion PIR sensor and at the same time blocked by ambient light. The consumption from the Li-ion battery in this mode is 1.5A - full power or 0.42A - half power.
- light activation mode when moving - PIR sensor is active: it can be set with the remote control to MODE1 or by repeatedly pressing the control button on the light body. In this mode, the luminaire will light at maximum power only when activated by the PIR sensor for 30 seconds and at the same time this function will be blocked by ambient light. The consumption from the Li-ion battery is 1.5A in this mode with the light on
- permanent light mode with activation of the maximum light by the PIR sensor: it can be set with the remote control to MODE2 or by repeatedly pressing the control button directly on the light body. In this mode, the light will be permanently lit at minimum power and the maximum light will be activated by the PIR sensor for 30 seconds. General lighting is blocked by ambient light. The consumption from the Li-ion battery is 0.04A permanently and 1.5A when activated by the PIR sensor.


Technical parameters:

- light source - LED COB, a total of 8 × panel of 20 LEDs
- luminous flux: 500lm at maximum power
- PIR sensor: 120 , sensitivity 3m
- remote control: IR, 6 buttons
- power supply: 2 × Li-ion cell 18650
- charging: solar cell 65 × 95mm 5V / 6W
- charging time: 8 hours in full sunlight
- the operating time depends on the operating mode. With a steady light at full power, the batteries last for about 2 hours, with occasional operation with a PIR sensor even for several days without charging.
- dimensions: 270 × 145 × 30mm, holder length 140mm
- weight: 500g

Warning: used cells may be uncharged. Before first use, leave for a few hours in direct sunlight or disassemble (6 screws), remove the cells and charge separately. When using quality cells with a capacity of 2500mAH, the operating time is extended proportionally.