ATmega328P bootloader programmer ch340 for arduino

- The DIY board has been burned bootloader for Arduino.

ATmega328P Development Board + CH340 Module + Cable USB to TTL Programmer

- It uses a locking seat, so it is easy to replace the chip.

- You can use CH340 USB to UART module include in the kit to burn the program.

- The program, expansion shields, development environment IDE is Compatible for Arduino.

- Microcontrollers: ATmega328P-PU

- Operating voltage: 5V

- IO interface logic voltage: 5V

- Operating Current: 500mA (max)

- Digital I / O pins: 14 (of which 6 can provide PWM output)

- Analog input pins: 6

- Clock frequency: 16MHz

- On-board test indicator LED, and the beginners can program to control it.

- Onboard power indicator.

- Bootloader burning Interface: ICSP

- Programming Interface: GND, 5V, RX, TX, DTR

Sender + 73,- med posten