7 000 kr
![Parasound 5125](https://images.finncdn.no/dynamic/480x480c//2024/9/vertical-0/07/6/365/403/836_b28c7b1e-72e5-4e7f-996d-388be1979417.jpg)
Tilstand: Som ny – Ikke synlig brukt
ThetaDreadnaught IV er en modulær effektforsterker, og kan fås i ulike konfigurasjoner med inntil 8 kanaler.
Det er tre ulike moduler med Bruno Putzeys' N-Core klasse D som er tilgjengelig for Dreadnaught IV. En stereomodul har oppgitt effekt på 225W i 8 ohm og 400W i 4 ohm. Det finnes også en mono-modul med tilsvarende spesifikasjoner som stereomodulen, mens den tredje tilgjengelige modulen er en brokoblet versjon, der effekten er 400W i 8 ohm og 600W i 4 ohm.
Input
1 Single-ended (RCA) per channel on each module.
1 Balanced (XLR) per channel on each module.
Input Impedance
47 kOhms. Single-Ended or Balanced, each phase.
Input sensitivity
Mono or Stereo module:
(Single-ended) 1.825V RMS input for 225W into 8 ohms.
(Balanced) 1.825V RMS input for 225W into 8 ohms.
Mono Bridged module
(Single-ended or Balanced) 1.825V RMS input for 500W into 8 ohms
Gain
(Single-Ended or Balanced) 27.8dB.
Polarity
(Single-ended) Non-Inverting.
(Balanced) Pin-2 = Positive, Pin-3 = Negative for Non-Inverting Output.
Output
One balanced output with 5-way binding posts per channel.
Modes/Processes
Standby: Amplifier is ready to be turned on via front panel switch or remote trigger.
Overcurrent, D.C., and/or thermal protection: Amplifier will cycle.
Catastrophic D.C. or output stage failure: Amplifier will shut down.
Power Output
Mono or Stereo Module
8 ohms: 225W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz:
4 ohms: 375W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz.
2 ohms: 500W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz.
Mono Bridged Module
8 ohms: 500W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz4 ohms: 800W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz.
Frequency Response
+0, -.5 dB 0Hz to 20 kHz, load independent.
Damping Factor
Greater than 6000 at 100 Hz; Greater than 2000 at any frequency up to and including 20 kHz.
Signal to Noise Ratio
120dB referenced to rated output (A-Weighted)
Crosstalk
-85 dB
Misc
Power Requirements
117V AC, 15A Slo BLo main fuse: 230V AC 8A Slo Blo main fuse; 50/60 Hz
Power Consumption
Less than 1W at Standby; less than 80W at idle; 1500W maximum by 2 when fully loaded
Trigger Input
5 to 12V DC; Steady State.
Dimensions
(W x H x D) 17 5/8 inches x 7 15/16 inches x 19 3/4 inches; 448 mm x 202mm x 502 mm
Weight
(fully loaded) 98.5 lbs; 44.8 kG
128 lbs with four stereo modules in the amplifier.
Maximum Operating Temperature
Internal: 176° F (80° C)
Room: 122° F (50° C)
Du må være logget inn for å se brukerprofiler og sende meldinger.
Logg innSist endret: 14.8.2024, 05:02 ・ FINN-kode: 360604140
Betalt plassering