Kite line and bridle cleat

Never have to untangle / untwist your lines or bridles again !

Picture this:

You check the forecast, conditions look stunning.

You pack the car, drive to your favorite spot and suit up.

It is a blue sky day, you can feel a nice breeze on your face and there is plenty of powder. It is damn cold though.

You skin up to the spot, remove the skins, set the binding on the skis, dress up again. Helmet, google, fleece, balaclava, harness.

You put on light gloves, or even no gloves at all, to be prepared to fiddle with the lines. Now your hands are exposed.

You start rigging the kite, only to find out your bridles on your foil kite, and the lines on your bar are a mess because you did not bother to take the time to pack them properly on your last session.

Now you are mad about yourself because you are about to spend 20 minutes untangling all this, with your hands freezing, walking and wandering about in deep loose snow, losing amazing practice time. You know the excuse for the delay is not going to fly with your partner back home.

Does it ring a bell ?

Never waste time on rigging anymore. The kite cleat keep your bridles and line sorted. It can go on the kite side, on the bridles, to keep them sorted when you swap the bar over to another kite. Or on the bar to keep the lines ends sorted, so it is ready to reconnect without having to walk the lines.

It works with foil kite, leading edge inflatable kite, and all type of bars. It can be used on snow or at the beach. It is also convenient where there is little space to rig, or for boat launch.

It captures the lines with a spring loaded design.

It is brand new, 3D printed and assembled on demand.

Color may vary