Advent Prodigy Tower

Selger et utmerket par vintage Advent Prodigy Tower høyttalersystem inkluderer høyttaler stativer som er 100 % funksjonelle og fysisk tiltakende

Det er noen små riper etter alder og bruk som er normalt.

oppheng på høyttalerne ble erstattet av en spesialist og ble matchet med maksimal nøyaktighet i størrelse og vekt til originalen

godt egnet for å lytte til vinylplater (blues, jazz, rock fra 70-90-tallet

The Advent Prodigy Tower, a compact, floor-standing two-way speaker system, measures 28-1/2 inches tall, 10-1/2 inches wide, and 8-7/8 inches deep and weighs 25-1/4 pounds. Although its proportions probably justify the "Tower" name, it could be described more accurately as a minitower, for it will not dominate even the smallest room.

The cabinet, which appears to be made of 1/2-inch-thick fiberboard, is painted flat black on four sides. The top is covered by a solid piece of oiled pecan wood, and there's a matching trim plate on the bottom of the front panel. With the black grille cloth in place, the speaker presents an all-black exterior except for the accents of light-colored wood. The spring-loaded input connectors, recessed into the rear of the speaker, accept the stripped ends of speaker wires.

The 8-inch, long-excursion woofer, which operates in a sealed enclosure, is located in the middle of the front panel, with the driver's center about 16 inches from the floor. At 3,000 Hz there is a crossover to a 3/4-inch, soft-dome tweeter (cooled and damped by ferrofluid) located near the top of the panel. The nominal system impedance is 6 ohms, with a minimum of 4 ohms. The rated sensitivity is 89 dB sound-pressure level (SPL) at 1 meter with a 2.8-volt input, and the speaker is recommended for use with amplifiers capable of delivering up to 75 watts continuous or 300 watts peak.

Advent gives the frequency response of the Prodigy Tower as 45 to 23,000 Hz ±3 dB, with a useful lower limit of 37 Hz (where its output is - 8 dB). The tweeter's output variation (dispersion) over a 30-degree angle, either vertical or horizontal, is rated as ± 1 dB. The system's harmonic distortion with a 1-watt input level is rated as less than 0.8 percent above 80 Hz