Crestron SWAMP-24X8 Sonnex® Multiroom Audio System med DSP, 16x 240W @4ohms

Har flere SWAMP-24X8 inklusiv ekspansjons forsterkere. Disse er super fine forsterkere som har innebygget DSP.

link til hoved enhet som er på bildet: https://www.crestron.com/Products/Audio/Multiroom-Audio/Multiroom-Audio-Systems/SWAMP-24X8

Brukeren bør ha litt forståelse av Crestron for å sette opp riktig.

Alternativ kan denne brukes i et multikanals system med aktiv delefilter på alle høyttalere.

Eksempelvis kan et 11.4.4 system med treveis aktivt deling av alle kanaler løses med en slik forsterker og 2 ekspansjons forsterkere. SWAMPE-8

Link: https://www.crestron.com/Products/Audio/Multiroom-Audio/Multiroom-Audio-Systems/SWAMPE-8

Dette er kun for proffer og nerder:-)

Bør hentes eller kjøper ordner frakt.

Frakt kan eventuelt avtales men det krevet mye innpakning:

Alder ca 6-7 år.

spec:

Audio

Input Signal Types Sonnex® Link

Output Signal Types Stereo speaker level

Typical of up to 8 amplified stereo zone outputs:

Digital-To-Analog Conversion 24-bit 48 kHz

Output Power 140 Watts per channel at 8 Ohms;

240 Watts per channel at 4 Ohms;

400 Watts per channel at 8 Ohms bridged

Damping Factor >200 @ 20 Hz

Amplifier Monitoring Over Current, Over/Under Voltage, Over Temperature, DC Offset, Clipping

Frequency Response 20 Hz to 20 kHz ±0.5 dB

THD 0.02%

S/N Ratio >105dB SPDIF in, >100dB balanced or unbalanced analog in, A-weighted

Stereo Separation >90dB

Zone Separation >95dB

Zone Volume Level Control -80.0 to +20.0 dB, adjustable from 0% to 100% plus mute

Bass Control ±12.0 dB

Treble Control ±12.0 dB

Loudness Compensation On/Off

Dynamic Range Control On/Off

Balance Control Left/right adjustable

Mono Summing Selectable

Power Limiting Sonnex Speaker Protect™ (SSP®) output limiting; configurable 40 to 140 Watts @ 8 Ohms, 40 to 240 Watts @ 4 Ohms, 40 to 400 Watts @ 8 Ohms bridged

Tone Profiles Flat, Classical, Jazz, Pop, Rock, Spoken Word

EQ Modes 5-band graphic or 5-band parametric EQ

GEQ Center Frequencies 63, 250, 1k, 4k, 16k Hz

GEQ Gain ±12.0 dB per band

PEQ Filter Types EQ, High Pass, Low Pass, Treble Shelf, Bass Shelf, Notch

PEQ Center Frequency 10 to 20,000 Hz per band

PEQ Gain ±12.0 dB per band

PEQ Bandwidth 0.1 to 3.5 octaves per band

Speaker Profiles Comprises 5-band GEQ and SSP settings

Bus Volume Offset ±12.0 dB per zone for output bussing

Communications

Sonnex Link 64-channel (48 utilized) digital audio w/embedded control, auto-discovery, auto-negotiating

Connectors

DIGITAL IN (1) 8-wire RJ45 female;

Sonnex link input;

Connects to SWAMP-24X8 Multiroom Audio System[1,2]

FUSE (US/North America) Main fuse, T15AH;

(1/4" x 1-1/4", 250V, 15A, time-lag, high-rupture rated)

FUSE (International) Main fuse, T8AH;

(1/4" x 1-1/4", 250V, 8A, time-lag, high-rupture rated)

120V~50/60Hz MAX 12A (US/North America) (1) IEC 60320 C14 main power inlet;

Mates with removable power cord (included);

A dedicated 15 Amp circuit is strongly recommended

220-240V~50/60Hz MAX 6A (International) (1) IEC 60320 C14 main power inlet;

Mates with removable power cord (included);

A dedicated 10 Amp circuit is strongly recommended

G 6-32 screw, chassis ground lug

SPEAKER OUTPUTS LEFT/RIGHT 1 – 8 (16) 2-pin 7.62mm 15A detachable terminal blocks;

Power amplifier outputs;

Wire Size: Terminals accept up to 14 AWG

Controls & Indicators

On/Off (1) Rocker switch, turns unit on and off

PWR (1) green LED, indicates unit is turned on

ZONE 1 – 8 (8) pushbuttons and green LEDs, select output zone for routing and adjustment

DIGITAL IN (rear) (1) green and (1) amber LEDs, green indicates link status and amber indicates data communication

Bridging (rear) (8) red LEDs, indicate adjacent outputs are configured for bridged operation

Power Requirements

Main Power

(US/North America) 12 Amps @ 120 Volts AC, 50/60 Hz (a dedicated 15 Amp circuit is strongly recommended)

Main Power (International) 6 Amps @ 220-240 Volts AC, 50/60 Hz (a dedicated 10 Amp circuit is strongly recommended)

Environmental

Temperature 41° to 104°F (5° to 40°C)

Humidity 10% to 90% RH (non-condensing)

Heat Dissipation 475 BTU/Hr (140W@8Ω), 750 BTU/Hr (240W@4Ω)

Enclosure

Chassis Metal with black finish, vented sides, variable-speed fan-cooled

Front Panel Metal, black finish with polycarbonate label overlay

Mounting Freestanding or 3U 19-inch rack-mountable (feet and rack ears included)

Dimensions

Height 5.83 in (149 mm);

5.20 in (133 mm) without feet

Width 19.0 in (483 mm);

17.29 in (439 mm) without rack ears

Depth 18.22 in (463 mm)

Weight

60.0 lb (27.3 kg)

Click here to search product certificates.

Item(s) sold separately.

For connection of the Sonnex Link between the SWAMPE-8 and SWAMP-24X8, use Crestron DM-CBL-8G or high-quality CAT5e shielded twisted-pair cable. The maximum cable length using DM-CBL-8G or CAT5e is 200 ft (61 m). For longer distances, use the S-EXT1-S Sonnex Link over Fiber Extender.