Ko propo RSx3 response servo 1/8 1/10

Pent brukt racing servo for 1/10 og 1/8 biler.

Leveres i emballasje som avbildet.

Kan sendes

Vipps eller fiks ferdig.

Spesifikasjoner

7.4V Torque: 17.6 Kg-cm (244 oz-in)

7.4V Speed: 0.06 sec/60°

6.0V Torque: 14.5 Kg-cm (201 oz-in)

6.0V Speed: 0.07 sec/60°

Dimensions: 41x38x20cm(Standard size)

Weight: 65.5g

Voltage: 6.0v - 7.4v lipo

Detaljert informasjon fra produsent:

This is KO PROPO RSx3 Response High Speed Digital Servo High Voltage For 1/8 1/10 RC.

The aluminum top case support the stable ‘Holding Power’. The case is machined after anodizing, creating a sharp design and beautiful edge line of the case. By shaving off the inside of the case to extremity, while securing sufficient strength, the case is made lighter than the former aluminum case. The black wire servo leads with cool appearance provides suitable softness for installation, while securing necessary current capacity.

HCS (High speed Communcation System): is the new high speed communication system between the receiver to the servo. The HCS mode shortens communication time of the signal which is compressed. HCS compatible servos is changing mode automatically by signal from receiver. So HCS compatible servos can use with all receivers. If you want to use servos by HCS, please use with HCS compatible receivers.

Case: The middle case is machined from one piece of aluminum that incorporates the gear pins and motor being held properly in place. The top case rigidity has been improved with the addition of two screws in the middle to prevent flex and keep the gears properly aligned. The upper Hard Case (H.C) is also machined from aluminum. H.C is the distinction of durability for categories that demand high stress.

Motor: A servo motor is a very important part of a servo. The specification of a servo is up to the motor being used. We have developed a new motor suitable for the new R/C standard with numerous performance and stress tests.

Gear: The gears are made with a special Japanese aluminum. This gear is 45% lighter than brass and has the same hardness as steel. The ‘Light Weight’ design provides a clean response for driving and reduces the burden on the servo motor. The thorough quality control of the manufactured gears ensures the least amount of backlash possible for smooth action. And Power and Pawer HC use Special Stainless Gear. It is very strong and useful for off load category.