Sequential Prophet Rev2, 16 voice

Selger min Prophet rev2 16 voice polysynth. Denne er så vidt et år gammel, og kun spilt i oppsettet mitt her hjemme. Jeg er eneste eier. Ser helst at den prøvespilles og hentes her på Råholt, men kan sendes gjennom "Fiks ferdig".

Spec fra Sequential sine sider:

Prophet Rev2 Specifications

OSCILLATORS

2 digitally controlled analog oscillators (DCOs) per voice (plus sub octave on oscillator 1) with selectable sawtooth, triangle, saw/triangle mix, and pulse waves (with pulse-width modulation)

Glide (portamento): separate rates per oscillator

White noise generator

Analog VCAs

Hard sync

FILTERS

1 analog Curtis low-pass filter per voice, selectable 2- and 4-pole operation (self-resonating in 4-pole mode)

ENVELOPES

3 envelope generators: filter, VCA, and assignable (four-stage ADSR + delay); Envelope 3 can loop.

SEQUENCER

Polyphonic step sequencer with up to 64 steps (6 notes per step), and ties and rests. Separate 16 x 4 gated step sequencer. Each layer can have a separate sequence.

LFOS

4 LFO’s with key sync per LFO

MODULATION

8-slot modulation matrix

22 sources

53 destinations

5 additional dedicated sources: mod wheel, pressure, velocity, breath controller, footswitch

ARPEGGIATOR

Programmable arpeggiator with up, down, up+down, random, assign modes

Selectable note value: 16th note, 8th note triplet, 8th note, dotted 8th note, quarter note

One, two, or three octave range

Re-latching arpeggiation

Note repeat

CONTROLS

5-octave keyboard with semi-weighted action, velocity, and aftertouch

55 knobs and 35 buttons enable deep and comprehensive editing with little to no menu diving.

Spring-loaded pitch wheel and assignable mod wheel

MEMORY

512 Factory Programs (4 banks of 128) and 512 fully editable User Programs with 2 layers (2 separate sounds) in each Program

IN/OUT

MIDI In, Out, Thru

Main stereo audio output: 1/4″ unbalanced

Output B stereo audio output: 1/4″ unbalanced

Sustain pedal input: accepts normally on or normally off momentary footswitch.

Pedal/CV input: responds to expression pedals or control voltages ranging from 0 to 5 VDC (protected against higher or negative voltages).

Headphone output: 1/4″ stereo phone jack.

POWER

IEC AC power inlet for internal power supply

Operates worldwide on voltages between 100 and 240 volts at 50 to 60 Hz

Power consumption: 22 watts maximum (17 watts for 8-voice configuration; 22 watts for 16-voice configuration)

PHYSICAL SPECS

Oiled African mahogany wood end panels

Dimensions: 12.70″ (32.26 cm) W x 35.12″ (89.20 cm) L x 3.80″ (9.65 cm) H (2.30″ at front edge; the feet account for 0.25″ of the total height)

Weight: 20.5 lbs. (9.3 kg)