Bildegalleri
Cisco POE80U-560(G)-C-R (80W Power injector for outdoor series wireless AP)
Beskrivelse av varen
Tilstand: Som ny - Ikke synlig brukt
Type: Annet
Manufacturer: Cisco (by Phihong Electronics Co., Ltd.)
Model: POE80U-560(G)-C-R
Product Category: Power over Ethernet (PoE)
Input Voltage (nominal): 90 VAC to 264 VAC
Number of Outputs: 1
Output Power Rating: 80 W
Output Voltage: 56 V
Output Current: 0.72 A
Corresponding P/NS: 341-0257-01, AIR-PWRINJ1500-2=
Overview
The power injector combines 56-VDC power (supplied by internal power supply) with the data signal, sending both to the access point. The power injector provides up to 80 W over all four wire pairs of shielded, outdoor rated Ethernet cable.
Ensure that the length of the Ethernet cable from the AP to the power injector is more than 10 ft (3 m), but less than 140 ft (42 m). The total length of the cable from the AP to the switch must not exceed 320 ft (100 m). The wire gauge of the cable must be 26 AWG.
The Ethernet cable from the switch to the power injector must be a shielded CAT5e or higher Ethernet cable. The Ethernet cable from the power injector to the access point must be a shielded outdoor-rated CAT5e or higher Ethernet cable with a 0.20 to 0.35 inch diameter.
A shielded, outdoor Ethernet cable connects the power injector to a 10/100/1000 Ethernet switch, hub, or network, and another shielded, outdoor cable carries power and data to the access point’s Ethernet port. The power injector’s AC power receptacle connects an approved AC power cord to a wall outlet or power strip. The power injector can be mounted on most horizontal and vertical surfaces, but must be mounted in a vertical orientation to comply with safety requirements.
*1pc available
Can be pick-up at my address in Oslo or send if desired but buyer pays the shipping.
Brukerprofil
Du må være logget inn for å se brukerprofiler og sende meldinger.
Logg innAnnonsens metadata
Sist endret: 25.3.2025 kl. 10:09 ・ FINN-kode: 399147865
